Yellow Boat 4
Twin NQD jets modified with brass stern tubes.
I have alternate nozzels which are a little larger than standard also.
Brass impellers made from cutdown brass props
Two P2632 Brushless Outrunner 3800kv Brushless
Stern Tubes brass shafts wrapped in PTFE tape until they fit the tubes. Will be setting up air cooling system with small EDF fan.
Will probably run two 2200mAh Lipos and 50 Amp aero ESCs with big heatsinks
For the cooling I may have the Arduino open and close a vent with a servo if the heatsinks get hot, as well as controlling the fan speed.
For the cooling I may have the Arduino open and close a vent with a servo if the heatsinks get hot, as well as controlling the fan speed.
Based on yellow boat plans different deck 390 Grams as shown
Also Ply fiberglass epoxy catamaran build log
Glass and epoxy inside balsa ply, will epoxy the outside too. Its very strong with builders fiberglass tape and epoxy
Also Ply fiberglass epoxy catamaran build log
Glass and epoxy inside balsa ply, will epoxy the outside too. Its very strong with builders fiberglass tape and epoxy
The motors will be mounted further forward on a cooled plate
Spray rails are bamboo barbecue skewers and wood filler
0 comments:
Post a Comment